SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE SL, 4WDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALPOWER CONTROL SYSTEM (POWER DISTRIBUTION SYSTEM)DTC/CIRCUIT DIAGNOSISDTC B261A: PUSH-BUTTON IGNITION SWITCHDTC LOGICDTC DETECTION LOGIC
2013 Nissan-Datsun Juke SL, 4WD

DTC Detection Logic

2013 Nissan-Datsun Juke SL, 4WDSECTION DTC Detection Logic
NOTE:
  • If DTC B261A is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to "DTC LOGIC ".
  • If DTC B261A is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to "DTC LOGIC ".
DTC No. Trouble diagnosis name DTC detecting condition Possible cause
B261A PUSH-BTN IGN SW BCM detects a difference of signal for 1 second or more between the following items.
  • Push-button ignition switch signal
  • Push-button ignition switch status signal (CAN)
  • Harness or connectors (Push-button ignition switch circuit is open or shorted.)
  • BCM
  • IPDM E/R
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.