Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE S, FWDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROL SYSTEM
2013 Nissan-Datsun Juke S, FWD
Brake Control System
2013 Nissan-Datsun Juke S, FWDSECTION Brake Control System
- Precaution
- Preparation
- System Description
- Component Parts
- System
- System Description
- Notes
- System Diagram
- Input Signal And Output Signal
- Valve Operation [VDC Function, TCS Function And Brake Limited Slip Differential (BLSD) Function
- Valve Operation (Abs Function And EBD Function)
- Notes
- When Brake Pedal is Applied or ABS Function is in Operation (During Pressure Increases)
- When ABS Function is Starts Operating (During Pressure Holds)
- When ABS Function is in Operation (During Pressure Decreases)
- When ABS Function is in Operation (During Pressure Increases)
- When Brake Release
- Component Parts and Function
- Condition For Turn On The Warning Lamp
- Condition For Turn On The Indicator Lamp
- Fail-safe
- VDC Function
- TCS Function
- Abs Function
- EBD Function
- Brake Limited Slip Differential (BLSD) Function
- System Description
- Diagnosis System [Abs Actuator And Electric Unit (Control Unit)]
- Ecu Diagnosis Information
- Wiring Diagram
- Basic Inspection
- DTC/Circuit Diagnosis
- DTC Index
- DTC C1101, C1102, C1103, C1104: Wheel Sensor
- DTC C1105, C1106, C1107, C1108: Wheel Sensor
- DTC C1109: Power And Ground System
- DTC C1110, C1170: Abs Actuator And Electric Unit (Control Unit)
- DTC C1111: Abs Motor, Motor Relay System
- DTC C1113, C1145, C1146: Yaw Rate/Side/DECEL G Sensor
- DTC C1115: Wheel Sensor
- DTC C1116: Stop Lamp Switch
- DTC C1120, C1122, C1124, C1126: Abs In Valve System
- DTC C1121, C1123, C1125, C1127: Abs Out Valve System
- DTC C1130: Engine Signal
- DTC C1140: Actuator Relay System
- DTC C1143: Steering Angle Sensor
- DTC C1144: Incomplete Steering Angle Sensor Adjustment
- DTC C1155: Brake Fluid Level Switch
- DTC C1164, C1165: CV System
- DTC C1166, C1167: SV System
- DTC C1176: Stop Lamp SW2
- DTC U1000: Can Comm Circuit
- DTC U1010: Control Unit (Can)
- Power Supply And Ground Circuit
- Parking Brake Switch
- VDC Off Switch
- Abs Warning Lamp
- Brake Warning Lamp
- VDC Warning Lamp
- VDC Off Indicator Lamp
- Symptom Diagnosis
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.