SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE S, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTINFOTAINMENTAUDIO, VISUAL, NAVIGATION SYSTEM (AUDIO WITHOUT NAVIGATION)DTC/CIRCUIT DIAGNOSISSTEERING SWITCH SIGNAL GND CIRCUIT (STEERING SWITCH TO TEL ADAPTER UNIT)DIAGNOSIS PROCEDURE
2013 Nissan-Datsun Juke S, FWD

Diagnosis Procedure

2013 Nissan-Datsun Juke S, FWDSECTION Diagnosis Procedure
  1. CHECK STEERING SWITCH SIGNAL GROUND CIRCUIT (STEERING SWITCH TO TEL ADAPTER UNIT) 
    1. Turn ignition switch OFF.
    2. Disconnect TEL adapter unit connector and spiral cable connector.
    3. Check continuity between TEL adapter unit harness connector and spiral cable harness connector.
      TEL adapter unit Spiral cable Continuity
      Connector Terminal Connector Terminal
      M127 14 M33 33 Existed

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Repair harness or connector.

  2. CHECK SPIRAL CABLE 

    Check spiral cable.

    Is the inspection result normal? 

    YES: GO TO 3.

    NO: Replace spiral cable. Refer to "EXPLODED VIEW ".

  3. CHECK GROUND CIRCUIT 
    1. Connect TEL adapter unit connector.
    2. Check continuity between TEL adapter unit harness connector and ground.
      TEL adapter unit Ground Continuity
      Connector Terminal
      M127 14 Existed

      Is the inspection result normal? 

      YES: GO TO 4.

      NO: Replace TEL adapter unit. Refer to "REMOVAL AND INSTALLATION ".

  4. CHECK STEERING SWITCH 

    Check steering switch. Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: INSPECTION END

    NO: Replace steering switch. Refer to "EXPLODED VIEW ".

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.