Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE S, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALMOTORS, SWITCHES, RELAYSPOWER CONTROL SYSTEM (POWER DISTRIBUTION SYSTEM)DTC/CIRCUIT DIAGNOSISPUSH-BUTTON IGNITION SWITCH POSITION INDICATORCOMPONENT FUNCTION CHECK
2013 Nissan-Datsun Juke S, FWD
Component Function Check
2013 Nissan-Datsun Juke S, FWDSECTION Component Function Check
- CHECK FUNCTION
Check push-button ignition switch ("PUSH SWITCH INDICATOR") in Active Test Mode with CONSULT.
Test item Description PUSH SWITCH INDICATOR ON Position indicator Illuminates OFF Does not illuminate Is the inspection result normal?
YES: INSPECTION END
NO: Refer to "DIAGNOSIS PROCEDURE ".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.