Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE S, FWDREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALPOWER OUTLETREMOVAL AND INSTALLATION

2013 Nissan-Datsun Juke S, FWD

Removal and Installation: Removal

2013 Nissan-Datsun Juke S, FWDSECTION Removal And Installation

Remove cluster tray. Refer to "REMOVAL AND INSTALLATION ".
Pull out inner socket (1) by pushing the pawl (B) of the ring (2) from the inner socket hole (square) (A).

Fig 1: Identifying Inner Socket Hole, Socket, Ring And Pawl
Courtesy of NISSAN NORTH AMERICA, INC.
Press the ring pawl from the back of the cluster tray to remove the ring.

Fig 2: Identifying Ring Pawl Of Cluster Tray
Courtesy of NISSAN NORTH AMERICA, INC.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.