Inspection in Auto Active Test Mode

2013 Nissan-Datsun Juke S, FWDSECTION Inspection in Auto Active Test Mode

When auto active test mode is actuated, the following operation sequence is repeated 3 times.

Operation sequence Inspection location Operation
1 Rear window defogger 10 seconds
2 Front wiper motor LO for 5 seconds β†’ HI for 5 seconds
3
  • Parking lamp
  • License plate lamp
  • Tail lamp
  • Side marker lamp
  • Front fog lamp
10 seconds
4 Headlamp LO for 10 seconds β†’HI ON <==> OFF 5 times
5 A/C compressor (magnet clutch) ON <==> OFF 5 times
6 Cooling fan 50% duty for 5 seconds β†’ 100% duty for 5 seconds
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.