Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Selective Unlock Function
2013 Nissan-Datsun Juke S, FWDSECTION Selective Unlock Function
- When an LOCK signal is transmitted from keyfob, all doors are locked.
- When an UNLOCK signal is transmitted from keyfob once, driver side door is unlocked.
- Then, if an UNLOCK signal is transmitted from keyfob again, all other doors are unlocked.
How to change selective unlock mode.
With CONSULT
Selective unlock mode can be set to ON or OFF using CONSULT.
Refer to "DOOR LOCK: CONSULT FUNCTION (BCM - DOOR LOCK) ".
Without CONSULT
- ON/OFF can be switched when keyfob lock button and unlock button are pressed simultaneously for 5 seconds or more while steering lock is locked.
- When mode is switched, hazard warning lamp blinks.
OFF → ON: 3 blinks
ON → OFF: 1 blink
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.