Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnosis Procedure
- CHECK "DOOR LOCK-UNLOCK SET" SETTING IN "WORK SUPPORT"
- Select "DOOR LOCK" of "BCM" using CONSULT.
- Select "DOOR LOCK-UNLOCK SET" in "WORK SUPPORT" mode.
- Check "DOOR LOCK-UNLOCK SET" in "WORK SUPPORT"
Refer to "DOOR LOCK: CONSULT FUNCTION (BCM - DOOR LOCK) ".
Is the inspection result normal?
YES: GO TO 2
NO: Set "DOOR LOCK-UNLOCK SET" in "WORK SUPPORT".
- REPLACE BCM
- Replace BCM. Refer to "REMOVAL AND INSTALLATION ".
- Confirm the operation after replacement.
Is the result normal?
YES: INSPECTION END
NO: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.