Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013JUKE NISMO, FWDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSDOOR & LOCK (WITH INTELLIGENT KEY SYSTEM)DTC/CIRCUIT DIAGNOSISHAZARD FUNCTIONCOMPONENT FUNCTION CHECK
2013 Nissan-Datsun Juke Nismo, FWD
Component Function Check
2013 Nissan-Datsun Juke Nismo, FWDSECTION Component Function Check
- CHECK FUNCTION
- Select "INTELLIGENT KEY" of "BCM" using CONSULT.
- Select "FLASHER" in "ACTIVE TEST" mode.
- Check that the function operates normally according to the following conditions.
Monitor item Status FLASHER LH Front turn signal lamp LH Turns ON RH Front turn signal lamp RH Turns ON OFF Front turn signal lamp Turns OFF Is the inspection result normal?
YES: Hazard warning lamp circuit is OK.
NO: Refer to "DIAGNOSIS PROCEDURE ".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.