Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Function Check
2013 Nissan-Datsun Juke Nismo, FWDSECTION Component Function Check
- CHECK FUNCTION
- Select "DOOR LOCK" of "BCM" using CONSULT.
- Select "CDL LOCK SW", "CDL UNLOCK SW" in "DATA MONITOR" mode.
- Check that the function operates normally according to the following conditions.
Monitor item Condition Status CDL LOCK SW Door lock and unlock switch Lock ON Unlock OFF CDL UNLOCK SW Lock OFF Unlock ON Is the inspection result normal?
YES: Door lock and unlock switch is OK.
NO: Refer to "DIAGNOSIS PROCEDURE ".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.