Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSNISSAN-DATSUN2013370Z BASE, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSDTC INDEXBRAKE CONTROL SYSTEM (VDC/TCS/ABS) DTCS

2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard Trans

Brake Control System (VDC/TCS/Abs) DTCS

2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard TransSECTION Brake Control System (VDC/TCS/Abs) DTCS

BRAKE CONTROL SYSTEM (VDC/TCS/ABS) DIAGNOSTIC TROUBLE CODES (DTC) LIST

DTC	Description
DTC C1101, C1102, C1103, C1104: WHEEL SENSOR	WHEEL SENSOR
DTC C1105, C1106, C1107, C1108: WHEEL SENSOR	WHEEL SENSOR
DTC C1109: POWER AND GROUND SYSTEM	POWER AND GROUND SYSTEM
DTC C1110, C1153, C1170: ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)	ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
DTC C1111: ABS MOTOR, MOTOR RELAY SYSTEM	ABS MOTOR, MOTOR RELAY SYSTEM
DTC C1115: WHEEL SENSOR	WHEEL SENSOR
DTC C1116: STOP LAMP SWITCH	STOP LAMP SWITCH
DTC C1120, C1122, C1124, C1126: IN ABS SOL	IN ABS SOL
DTC C1121, C1123, C1125, C1127: OUT ABS SOL	OUT ABS SOL
DTC C1130: ENGINE SIGNAL	ENGINE SIGNAL
DTC C1140: ACTUATOR RELAY SYSTEM	ACTUATOR RELAY SYSTEM
DTC C1142: PRESS SENSOR	PRESS SENSOR
DTC C1143: STEERING ANGLE SENSOR	STEERING ANGLE SENSOR
DTC C1144: INCOMPLETE STEERING ANGLE SENSOR ADJUSTMENT	INCOMPLETE STEERING ANGLE SENSOR ADJUSTMENT
DTC C1145, C1146: YAW RATE/SIDE G SENSOR	YAW RATE/SIDE G SENSOR
DTC C1147, C1148, C1149, C1150: USV/HSV LINE	USV/HSV LINE
DTC C1155: BRAKE FLUID LEVEL SWITCH	BRAKE FLUID LEVEL SWITCH
DTC U1000: CAN COMM CIRCUIT	CAN COMM CIRCUIT
DTC U1002: SYSTEM COMM (CAN)	SYSTEM COMM (CAN)

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.