Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013370Z BASE, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESUN ROOF/T-TOP/CONVERTIBLE TOPDTC/CIRCUIT DIAGNOSISDTC B170A: ROOF OPEN/CLOSE SWITCH (CLOSE)DTC LOGICDTC CONFIRMATION PROCEDURE
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard Trans
DTC Confirmation Procedure
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard TransSECTION DTC Confirmation Procedure
- CHECK ROOF OPEN/CLOSE SWITCH SIGNAL
- Start engine.
- Operate soft top to fully open and fully close.
- Select "Self Diagnostic Result" mode of "CONVERTIBLE ROOF" using CONSULT.
- Check DTC.
Is DTC detected?
YES: Go to "DIAGNOSIS PROCEDURE ".
NO: INSPECTION END
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.