Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013370Z BASE, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATS (REGULAR GRADE)
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard Trans
Seats (Regular Grade)
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard TransSECTION Seats (Regular Grade)
- Basic Inspection
- System Description
- DTC/Circuit Diagnosis
- Power Supply And Ground Circuit
- Climate Controlled Seat Switch
- Seatback Thermal Electric Device
- Seatback Thermal Electric Device Sensor
- Seat Cushion Thermal Electric Device
- Seat Cushion Thermal Electric Device Sensor
- Climate Controlled Seatback Blower Motor
- Climate Controlled Seat Cushion Blower Motor
- Climate Controlled Seat Switch Indicator
- Climate Controlled Seat Blower Filter
- Power Seat
- Heated Seat
- Ecu Diagnosis Information
- Symptom Diagnosis
- Climate Controlled Seat Does Not Operate
- Temperature Adjustment Is Impossible
- Climate Controlled Seat Does Not Operates When Switch Is Done In Heat Or Cool
- Climate Controlled Seat Activates Once But Stops Immediately
- Seat Switch Indicator Is Not Illuminated In Heat Or Cool Position
- Squeak And Rattle Trouble Diagnosis
- Precaution
- Preparation
- Removal And Installation
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.