Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2013370Z BASE, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSSECURITY CONTROL SYSTEMSYSTEM DESCRIPTIONINTELLIGENT KEY SYSTEM/ENGINE START FUNCTIONCOMPONENT DESCRIPTION
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard Trans
Component Description
2013 Nissan-Datsun 370Z Base, 2D Convertible, Standard TransSECTION Component Description
| Component | Reference |
|---|---|
| BCM | B2619 BCM |
| Push-button ignition switch | B2556 PUSH-BUTTON IGNITION SWITCH |
| Door switch | REMOTE KEYLESS ENTRY RECEIVER or TRUNK LID OPENER ACTUATOR |
| A/T shift selector (detention switch) (A/T models) | B210F PNP/CLUTCH INTERLOCK SWITCH |
| Inside key antenna | REMOTE KEYLESS ENTRY RECEIVER or TRUNK LID OPENER ACTUATOR |
| Remote keyless entry receiver | REMOTE KEYLESS ENTRY RECEIVER or TRUNK LID OPENER ACTUATOR |
| Stop lamp switch | B2555 STOP LAMP |
| TCM (A/T models) | B2604 PNP SWITCH |
| Clutch interlock switch (M/T models) | B26E8 CLUTCH INTERLOCK SWITCH |
| Starter relay | B2608 STARTER RELAY |
| Starter control relay | B210B STARTER CONTROL RELAY |
| Security indicator lamp | SECURITY INDICATOR LAMP |
| Key warning lamp | KEY WARNING LAMP |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.