Input/Output Signal Chart

2012 Nissan-Datsun Xterra S, 4WD, Automatic TransSECTION Input/Output Signal Chart
Sensor Input Signal to ECM ECM function Actuator
Air conditioner switch Air conditioner ON signal(1) Air conditioner cut control Air conditioner relay
Accelerator pedal position sensor Accelerator pedal position
Crankshaft position sensor (POS)
Camshaft position sensor (PHASE)
Engine speed(2)
Engine coolant temperature sensor Engine coolant temperature
Battery Battery voltage(2)
Refrigerant pressure sensor Refrigerant pressure
Power steering pressure sensor Power steering operation
Wheel sensor Vehicle speed(1)
(1) This signal is sent to the ECM via the CAN communication line.
(2) ECM determines the start signal status by the signals of engine speed and battery voltage.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.