Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012XTERRA S, 4WD, AUTOMATIC TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM - DTCS P0222 TO P0603DTC P0452: EVAP CONTROL SYSTEM PRESSURE SENSORCOMPONENT INSPECTIONEVAP CONTROL SYSTEM PRESSURE SENSOR
2012 Nissan-Datsun Xterra S, 4WD, Automatic Trans
EVAP Control System Pressure Sensor
2012 Nissan-Datsun Xterra S, 4WD, Automatic TransSECTION EVAP Control System Pressure Sensor
- Remove EVAP control system pressure sensor with its harness connector connected from EVAP canister. Refer to
"REMOVAL AND INSTALLATION
".
Do not reuse the O-ring, replace it with a new one.
- Install a vacuum pump to EVAP control system pressure sensor.
- Turn ignition switch ON and check output voltage between ECM terminal 32 and ground under the following conditions.
Applied vacuum kPa (kg/cm2 , psi) Voltage V Not applied 1.8 - 4.8 -26.7 (-0.272, -3.87) 2.1 to 2.5V lower than above value CAUTION:- Always calibrate the vacuum pump gauge when using it.
- Never apply below -93.3 kPa (-0.952 kg/cm2 , -13.53 psi) or pressure over 101.3 kPa (1.033 kg/cm2 , 14.59 psi).
- If NG, replace EVAP control system pressure sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.