Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnosis Procedure
- CHECK OVERALL FUNCTION
Check ASCD indicator under the following conditions.
ASCD INDICATOR CONDITION SPECIFICATION CRUISE LAMP - Ignition switch: ON
MAIN switch: pressed at the 1st time → at the 2nd time ON → OFF SET LAMP - MAIN switch: ON
- When vehicle speed is between 40 km/h (25 MPH) and 144 km/h (89 MPH)
ASCD: Operating ON ASCD: Not operating OFF OK or NG
OK: INSPECTION END
NG: GO TO 2.
- CHECK DTC
Check that DTC UXXXX is not displayed.
OK or NG
OK: GO TO 3.
NG: Perform trouble diagnoses for DTC UXXXX.
- CHECK COMBINATION METER FUNCTION
Refer to "WORK FLOW ".
OK or NG
OK: GO TO 4.
NG: Go to MWI-5, "METER SYSTEM: System Diagram".
- CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".
: INSPECTION END
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.