Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2012 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Adjustment of CVT Position
CAUTION:
Make sure that parking brake is applied before adjustment.
- Loosen the control cable nut and place the manual lever in "P" position.
- Place shift selector in "P" position.
- Temporarily tighten the control cable nut.NOTE: Do not move the manual lever. Make sure the manual lever stays in the "P" position.
- Tighten the control cable nut.
Control cable nut: Refer to "REMOVAL AND INSTALLATION ".
CAUTION: Secure the manual lever when tightening nut. - Check the operation of the CVT. Refer to "CHECKING OF CVT POSITION ".
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.