Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012SENTRA SE-RREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSMISSION (CVT)SERVICE INFORMATIONDTC P1745: LINE PRESSURE CONTROLDTC CONFIRMATION PROCEDUREWITH CONSULT
2012 Nissan-Datsun Sentra SE-R
With Consult
2012 Nissan-Datsun Sentra SE-RSECTION With Consult
- Turn ignition switch ON and select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT.
- Make sure that output voltage of CVT fluid temperature sensor is within the range below.
ATF TEMP SEN: 1.0 - 2.0 V
If out of range, drive the vehicle to decrease the voltage (warm up the fluid) or stop engine to increase the voltage (cool down the fluid)
- If DTC is detected, go to "DIAGNOSIS PROCEDURE ".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.