SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012SENTRA SE-RREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 9 (ENGINE CONTROL SYSTEM - INTRODUCTION (MR20DE) (CALIFORNIA))SERVICE INFORMATIONTROUBLE DIAGNOSISGENERIC SCAN TOOL (GST) FUNCTIONINSPECTION PROCEDURE
2012 Nissan-Datsun Sentra SE-R

Inspection Procedure

2012 Nissan-Datsun Sentra SE-RSECTION Inspection Procedure
WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF.
  2. Connect GST to data link connector (1).
    • Accelerator pedal (2)
    Fig 1: Identifying Data Link Connector And Accelerator Pedal
    G04925184Courtesy of NISSAN NORTH AMERICA, INC.
  3. Turn ignition switch ON.
  4. Enter the program according to instruction on the screen or in the operation manual.

    (*: Regarding GST screens in this information, sample screens are shown in the figure.)

    Fig 2: Display - GST Sample Screen
    G04874897Courtesy of NISSAN NORTH AMERICA, INC.
  5. Perform each diagnostic service according to each service procedure.

    For further information, see the GST Operation Manual of the tool maker  .

    Fig 3: Generic Scan Tool Screen Display - Readiness Tests
    G04874898Courtesy of NISSAN NORTH AMERICA, INC.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.