Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012SENTRA SE-RREPAIR AND DIAGNOSISBODY & FRAMESEATSSERVICE INFORMATIONFRONT SEATREMOVAL AND INSTALLATIONREMOVAL
2012 Nissan-Datsun Sentra SE-R
Removal and Installation: Removal
2012 Nissan-Datsun Sentra SE-RSECTION Removal
- Disconnect the negative and the positive battery terminals and wait at least three minutes.
- Remove the seat assembly bolts on the back side of the front seat.
- Remove the seat assembly bolts on the front side of the front seat
- Disconnect the body harness connector(s), then release the harness clips from the seat assembly.
- Remove the front seat assembly from the vehicle.NOTE: Before removing the seat assembly from the vehicle, adjust the seatback to the upright position.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.