SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012SENTRA SE-RREPAIR AND DIAGNOSIS (SINGLE PAGE)MAINTENANCEPROCEDURESMAINTENANCE REMINDER LIGHT (RESET PROCEDURES)MAINTENANCE SERVICE REMINDERMAINTENANCE SERVICE REMINDER RESET - PROCEDURE 05
2012 Nissan-Datsun Sentra SE-R

Maintenance Service Reminder Reset - Procedure 05

2012 Nissan-Datsun Sentra SE-RSECTION Maintenance Service Reminder Reset - Procedure 05

Maintenance intervals shown in the Vehicle Information Display (center of the instrument cluster) are reset using the Trip Computer switch. See Fig 1. When the ignition switch is ON, modes of the trip computer can be selected by pushing the (A) button briefly. Each time the button is pushed, the display will change modes. Press and hold to select. Use mode SETTINGS (6) for maintenance reminder adjustment or reset. See Fig 2.

NOTE: The SETTINGS mode cannot be accessed while driving.

Select MAINTENANCE from the SETTINGS menu. Press the (A) button briefly to highlight a menu item. Press and hold to select or reset. The maintenance intervals of the following items can be adjusted or reset for the reminders:

  • Service:  Select this menu to adjust the distance until next engine oil change, or reset the automatic reminder.
  • Tire:  Select this menu to adjust the distance until tires need replacing, or reset the automatic reminder.
  • Other:  Select this menu to adjust or reset items other than the engine oil, oil filter and tires. Other maintenance items can include such things as air filter or tire rotation.

To return to the top page of the SETTINGs menu, select BACK.

Fig 1: Identifying Trip Computer Reset Switch (Rogue)
G00464888Courtesy of NISSAN MOTOR CO., U.S.A.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.