Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Systems Controlled By IPDM E/R
- Lamp control
Using CAN communication lines, it receives signals from the BCM and controls the following lamps:
- Headlamps (High, Low)
- Parking lamps
- Tail and license plate lamps
- Front fog lamps
- Wiper control
Using CAN communication lines, it receives signals from the BCM and controls the front wipers.
- Rear window defogger relay control
Using CAN communication lines, it receives signals from the BCM and controls the rear window defogger relay.
- A/C compressor control
Using CAN communication lines, it receives signals from the ECM and controls the A/C compressor (magnet clutch).
- Starter control
Using CAN communication lines, it receives signals from the BCM and controls the starter relay.
- Cooling fan control
Using CAN communication lines, it receives signals from the ECM and controls the cooling fan relays.
- Horn control
Using CAN communication lines, it receives signals from the BCM and controls the horn relay.
- Daytime light system control (Canada only)
Using CAN communication lines, it receives signals from the BCM and controls the daytime light relay.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.