SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012SENTRA SE-RREPAIR AND DIAGNOSIS (SINGLE PAGE)DRIVELINES & AXLESAXLE SHAFTSFRONT AXLESERVICE INFORMATIONPRECAUTIONSGENERAL PRECAUTIONS
2012 Nissan-Datsun Sentra SE-R

General Precautions

2012 Nissan-Datsun Sentra SE-RSECTION General Precautions

Observe the following precautions when disassembling and assembling drive shaft.

  • Joint sub-assembly does not disassemble because it is non-overhaul parts.
  • Perform work in a location which is as dust-free as possible.
  • Before disassembling and assembling, clean the outside of parts.
  • Prevention of the entry of foreign objects must be taken into account during disassembly of the service location.
  • Disassembled parts must be carefully reassembled in the correct order. If work is interrupted, a clean cover must be placed over parts.
  • Paper shop cloths must be used. Fabric shop cloths must not be used because of danger of lint contacting to parts.
  • Disassembled parts (except for rubber parts) should be cleaned with kerosene which shall be removed by blowing with air or wiping with paper shop cloths.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.