Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Preliminary Check
- CHECK BCM CONFIGURATION
Confirm BCM configuration for "THEFT ALARM" is set to "WITH". Refer to , "CONFIGURATION ".
OK or NG
OK: Proceed with the preliminary check to verify system operation.
NG: Change BCM configuration for "THEFT ALARM" to "WITH". Refer to , "CONFIGURATION ".
The system operation is canceled by turning ignition switch to ACC at any step between START and ARMED in the following flow chart.
Courtesy of NISSAN NORTH AMERICA, INC.
After performing preliminary check, go to symptom chart. Refer to , "SYMPTOM CHART ".
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.