SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012SENTRA SE-RREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTANTI-THEFT SYSTEMSBODY, LOCK & SECURITY SYSTEMSERVICE INFORMATIONINTELLIGENT KEY SYSTEMTRUNK OPENER REQUEST SWITCH CHECK
2012 Nissan-Datsun Sentra SE-R

Trunk Opener Request Switch Check

2012 Nissan-Datsun Sentra SE-RSECTION Trunk Opener Request Switch Check
  1. CHECK TRUNK OPENER REQUEST SWITCH

    With CONSULT 

    Check trunk opener request switch ("BD/TR REQ SW") in "DATA MONITOR" mode.

    Monitor item Condition
    BD/TR REQ SW Trunk opener request switch is pressed: ON
    Trunk opener request switch is released: OFF

    Without CONSULT 

    1. Turn ignition switch OFF.
    2. Check voltage between Intelligent Key unit connector M42 terminal 29 and ground.
      Connector Terminals Condition Voltage (V) (Approx.)
      (+) (-)
      M42 29 Ground Trunk opener request switch is pressed 0
      Trunk opener request switch is released 5
      Fig 1: Checking Trunk Opener Request Switch
      G04916829Courtesy of NISSAN NORTH AMERICA, INC.

      OK or NG 

      OK: Trunk opener request switch is OK.

      NG: GO TO 2.

  2. CHECK TRUNK OPENER REQUEST SWITCH OPERATION
    1. Turn ignition switch OFF.
    2. Disconnect trunk opener request switch connector.
    3. Check continuity between trunk opener request switch terminals 1 and 2.
      Component Terminals Condition Continuity
      Trunk opener request switch 1 2 Trunk opener request switch is pressed Yes
      Trunk opener request switch is released No
      Fig 2: Checking Trunk Opener Request Switch Operation
      G04916830Courtesy of NISSAN NORTH AMERICA, INC.

      OK or NG 

      OK: GO TO 3.

      NG: Replace trunk opener request switch.

  3. CHECK TRUNK OPENER REQUEST SWITCH GROUND CIRCUIT

    Check continuity between trunk opener request switch harness connector T5 terminal 2 and ground.

    2 - Ground: Continuity should exist  .

    Fig 3: Checking Trunk Opener Request Switch Ground Circuit
    G04916831Courtesy of NISSAN NORTH AMERICA, INC.

    OK or NG 

    OK: GO TO 4.

    NG: Repair or replace trunk opener request switch ground circuit.

  4. CHECK TRUNK OPENER REQUEST SWITCH CIRCUIT
    1. Disconnect Intelligent Key unit connector.
    2. Check continuity between Intelligent Key unit harness connector M42 (A) terminal 29 and trunk opener request switch harness connector T5 (B) terminal 1.

      29 - 1: Continuity should exist  .

    3. Check continuity between Intelligent Key unit harness connector M42 (A) terminal 29 and ground.

      29 - Ground: Continuity should not exist  .

      Fig 4: Checking Trunk Opener Request Switch Circuit
      G04916832Courtesy of NISSAN NORTH AMERICA, INC.

      OK or NG 

      OK: GO TO 5.

      NG: Repair or replace harness between Intelligent Key unit and trunk opener request switch.

  5. CHECK TRUNK OPENER REQUEST SWITCH SIGNAL
    1. Connect Intelligent Key Unit connector.
    2. Check voltage between trunk opener request switch harness connector T5 terminal 1 and ground.

      1 - Ground: Battery voltage 

      Fig 5: Checking Trunk Opener Request Switch Signal
      G04916833Courtesy of NISSAN NORTH AMERICA, INC.

      OK or NG 

      OK: Check condition of harness and connector.

      NG: Replace Intelligent Key unit. Refer to , "REMOVAL AND INSTALLATION OF INTELLIGENT KEY UNIT ".

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.