Active Test

2012 Nissan-Datsun Sentra SE-RSECTION Active Test
Test item Description
DOOR LOCK/UNLOCK This test is able to check door lock/unlock operation.
  • The all door lock actuators are unlocked when "ALL UNLK" on CONSULT screen is touched.
  • The door lock actuator (driver side) is unlocked when "DR UNLK" on CONSULT screen is touched.
  • The door lock actuator (passenger side) is unlocked when "AS UNLK" on CONSULT screen is touched.
  • The all door lock actuators are locked when "LOCK" on CONSULT screen is touched.
ANTENNA This test is able to check Intelligent Key antenna operation.
When the following conditions are met, hazard warning lamps flash.
  • Inside key antenna (Instrument panel) detects Intelligent Key, when "RM ANT1" on CONSULT screen is touched.
  • Inside key antenna (Front console) detects Intelligent Key, when "RM ANT2" on CONSULT screen is touched.
  • Rear parcel shelf antenna detects Intelligent Key, when "LUG ANT" on CONSULT screen is touched.
  • Outside key antenna (LH side) detects Intelligent Key, when "DR ANT" on CONSULT screen is touched.
  • Outside key antenna (RH side) detects Intelligent Key, when "AS ANT" on CONSULT screen is touched.
  • Rear bumper antenna detects Intelligent Key, when "BK DR ANT" on CONSULT screen is touched.
OUTSIDE BUZZER This test is able to check Intelligent Key warning buzzer (front of vehicle) operation. Intelligent Key warning buzzer (front of vehicle) sounds when "ON" on CONSULT screen is touched.
INSIDE BUZZER (CHIME) This test is able to check Intelligent Key warning chime (combination meter) operation.
  • Take away warning chime sounds when "TAKE OUT" on CONSULT screen is touched.
  • Ignition switch warning chime sounds when "KNOB" on CONSULT screen is touched.
  • Ignition key warning chime sounds when "KEY" on CONSULT screen is touched.
INDICATOR This test is able to check warning lamp operation.
  • "KEY" Warning lamp (Green) illuminates when "BLUE ON" on CONSULT screen is touched.
  • "KEY" Warning lamp (Red) illuminates when "RED ON" on CONSULT screen is touched.
  • "P-SHIFT" Warning lamp illuminates when "KNOB ON" on CONSULT screen is touched.
  • "KEY" Warning lamp (Green) flashes when "BLUE IND" on CONSULT screen is touched.
  • "KEY" Warning lamp (RED) flashes when "RED IND" on CONSULT screen is touched.
  • "P-SHIFT" Warning lamp flashes when "KNOB IND" on CONSULT screen is touched.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.