Test Item

2012 Nissan-Datsun NV1500 SSECTION Test Item

SOLENOID VALVE

  • When performing an active test of the ABS function, select "MAIN SIGNALS" for each test item.
  • For ABS solenoid valve, touch "Up", "Keep", and "Down" on the display screen. For ABS solenoid valve (ACT), touch "Up", "ACT UP", "ACT KEEP" and confirm that solenoid valves operate as shown in the table below.
Operation ABS solenoid valve ABS solenoid valve (ACT)
Up Keep Down Up ACT UP ACT KEEP
FR RH SOL FR RH IN SOL Off On On - - -
FR RH OUT SOL Off Off On(1) - - -
FR LH SOL FR LH IN SOL Off On On - - -
FR LH OUT SOL Off Off On(1) - - -
RR RH SOL RR RH IN SOL Off On On - - -
RR RH OUT SOL Off Off On(1) - - -
RR LH SOL RR LH IN SOL Off On On - - -
RR LH OUT SOL Off Off On(1) - - -
FR RH ABS SOLENOID (ACT) FR RH IN SOL - - - Off Off Off
FR RH OUT SOL - - - Off Off Off
CV1 - - - Off On On
SV1 - - - Off On(1) Off
FR LH ABS SOLENOID (ACT) FR LH IN SOL - - - Off Off Off
FR LH OUT SOL - - - Off Off Off
CV1 - - - Off On On
SV1 - - - Off On(1) Off
RR RH ABS SOLENOID (ACT) RR RH IN SOL - - - Off Off Off
RR RH OUT SOL - - - Off Off Off
CV2 - - - Off On On
SV2 - - - Off On(1) Off
RR LH ABS SOLENOID (ACT) RR LH IN SOL - - - Off Off Off
RR LH OUT SOL - - - Off Off Off
CV2 - - - Off On On
SV2 - - - Off On(1) Off
(1) On for 1 to 2 seconds after the touch, and then OFF

STOP LAMP ON RELAY

  • Touch "On" and "Off" on screen. Make sure stop lamp on relay operates as shown in table below.
Operation On Off
STOP LAMP ON RELAY On Off
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.