SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012NV1500 SREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTINFOTAINMENTPREMIUM AUDIO SYSTEMECU DIAGNOSIS INFORMATIONAV CONTROL UNITREFERENCE VALUEPHYSICAL VALUES
2012 Nissan-Datsun NV1500 S

Physical Values

2012 Nissan-Datsun NV1500 SSECTION Physical Values
Terminal (Wire color) Description Condition Reference value (Approx.)
+ - Signal name Input/Output
2 (L) 3 (W) Sound signal front door speaker LH Output Ignition switch ON Sound output
G04879120
4 (L) 5 (W) Sound signal rear speaker LH (if equipped) Output Ignition switch ON Sound output
G04879120
6 (SB) 15 (LG) Steering switch signal A Input Ignition switch ON Press SOURCE switch 0 V
Press SEEK UP switch 1.4 V
Press SEEK DOWN switch 2.5 V
Press phone (SEND) switch 3.5 V
Except for above 5.0 V
7 (O) Ground ACC power supply Input Ignition switch ACC - Battery voltage
9 (V) 8 (BR) Illumination control signal Input Ignition switch ON
  • Lighting switch 1ST
  • When meter illumination is maximum
G05917979
  • Lighting switch 1ST
  • When meter illumination is step 11
G05917980
  • Lighting switch 1ST
  • When meter illumination is minimum
 0 V
11 (R) 12 (G) Sound signal front door speaker RH Output Ignition switch ON Sound output
G04879120
13 (R) 14 (G) Sound signal rear speaker RH (if equipped) Output Ignition switch ON Sound output
G04879120
16 (GR) 15 (LG) Steering switch signal B Input Ignition switch ON Press VOL DOWN switch 0 V
Press VOL UP switch 1.4 V
Press phone (END) switch 2.5 V
Except for above 5.0 V
18 (P) Ground Vehicle speed signal (8-pulse) Input Ignition switch ON When vehicle speed is approx. 25 mph (40 km/h)
NOTE: The maximum voltage varies depending on the specification (destination unit).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.