Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Saved Data List Reprogramming With Consult III Plus (NTB12-074)
2012 Nissan-Datsun Altima BaseSECTION Saved Data List Reprogramming With Consult III Plus (NTB12-074)
Publication date: 2012-09-12
Reference number: NTB12-074
SAVED DATA LIST REPROGRAMMING WITH CONSULT III PLUS
Reference number: NTB12-074
SAVED DATA LIST REPROGRAMMING WITH CONSULT III PLUS
TECHNICAL SERVICE BULLETIN
Reference Number(s): NTB12-074, Date of Issue:
September 12, 2012
| CLASSIFICATION: | EC12-021 |
| APPLIED VEHICLES: | All |
SERVICE INFORMATION
- When performing a "Reprogramming" operation with C-III plus, the screen in Figure 1 may display.
- This screen displays "Saved Data" from previous C-III plus operations.
- During the initial "Reprogramming Confirmation" set-up, if you get this screen:
- Select Delete , then
- Select Other Operation , then
- Continue with the reprogramming procedure.
NOTE:
If reprogramming does not complete, this screen can display for reprogramming recovery. Do not select Delete if this screen displays during reprogram recovery.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.