Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012370Z TOURING, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM - SYSTEM AND COMPONENT TESTINGFUEL PUMPCOMPONENT INSPECTION
2012 Nissan-Datsun 370Z Touring, 2D Convertible, Standard Trans
Component Inspection
2012 Nissan-Datsun 370Z Touring, 2D Convertible, Standard TransSECTION Component Inspection
- CHECK FUEL PUMP
- Turn ignition switch OFF.
- Disconnect "fuel level sensor unit and fuel pump" harness connector.
- Check resistance between "fuel level sensor unit and fuel pump" terminals as follows.
Terminals Resistance (Ω) 1 and 3 0.2 - 5.0 [at 25°C (77°F)] Is the inspection result normal?
YES: INSPECTION END
NO: Replace "fuel level sensor unit and fuel pump"
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.