Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2012370Z TOURING, 2D CONVERTIBLE, STANDARD TRANSREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM - DTCS P0130 THROUGH P0445DTC P0420, P0430: THREE WAY CATALYST FUNCTIONCOMPONENT FUNCTION CHECK
2012 Nissan-Datsun 370Z Touring, 2D Convertible, Standard Trans
Component Function Check
2012 Nissan-Datsun 370Z Touring, 2D Convertible, Standard TransSECTION Component Function Check
- PERFORM COMPONENT FUNCTION CHECK
Without CONSULT
- Start engine and warm it up to the normal operating temperature.
- Turn ignition switch OFF and wait at least 10 seconds.
- Start engine and keep the engine speed between 3, 500 and 4, 000 rpm for at least 1 minute under no load.
- Let engine idle for 1 minute.
- Open engine hood.
- Check the voltage between ECM harness connector terminals under the following condition.
DTC ECM Condition Voltage Connector + - Terminal Terminal P0420 F102 76 [HO2S2 (bank 1)] 84 Keeping engine speed at 2, 500 rpm constant under no load The voltage fluctuation cycle takes more than 5 seconds.
1 cycle: 0.6 - 1.0 → 0 - 0.3 → 0.6 - 1.0P0430 80 [HO2S2 (bank 2)] Is the inspection result normal?
YES: INSPECTION END
NO: Go to "DIAGNOSIS PROCEDURE ".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.