Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2009XTERRA SE, 4WDREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMENGINE CONTROL SYSTEM - INTRODUCTIONBASIC INSPECTIONINSPECTION AND ADJUSTMENTPROCEDURE AFTER REPLACING ECM
2009 Nissan-Datsun Xterra SE, 4WD
Procedure After Replacing ECM
2009 Nissan-Datsun Xterra SE, 4WDSECTION Procedure After Replacing ECM
When replacing ECM, the following procedure must be performed.
- Perform initialization of NVIS (NATS) system and registration of all NVIS (NATS) ignition key IDs. Refer to "ECM RE-COMMUNICATING FUNCTION : SPECIAL REPAIR REQUIREMENT ".
- Perform "VIN REGISTRATION ".
- Perform "ACCELERATOR PEDAL RELEASED POSITION LEARNING ".
- Perform "THROTTLE VALVE CLOSED POSITION LEARNING ".
- Perform "IDLE AIR VOLUME LEARNING ".
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.