Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2009SENTRA L4-2.0L (MR20DE)REPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTTRANSMISSION CONTROL SYSTEMSTESTING AND INSPECTIONSCAN TOOL TESTING AND PROCEDURESCONSULT-III FUNCTION (TRANSMISSION)
2009 Nissan-Datsun Sentra L4-2.0L (MR20DE)
CONSULT-III Function (Transmission)
2009 Nissan-Datsun Sentra L4-2.0L (MR20DE)SECTION CONSULT-III Function (Transmission)
TROUBLE DIAGNOSIS
CONSULT-III Function (TRANSMISSION)
CONSULT-III can display each diagnostic item using the diagnostic test modes shown below.
FUNCTION
CONSULT-III REFERENCE VALUE
WORK SUPPORT MODE
Display Item List
Engine Brake Adjustment
CAUTION:
Mode of "+1""0""-1""-2""OFF" can be selected by pressing the "UP""DOWN" on CONSULT-III screen.
However, do not select mode other than "0" and "OFF". If the "+1" or "-1" or "-2" is selected, that might cause the irregular driveability.
Check CVT Fluid Deterioration Date
CAUTION:
Touch "CLEAR" after changing CVT fluid, and then erase "CVTF DETERIORATION DATE".
SELF-DIAGNOSTIC RESULT MODE
After performing self-diagnosis, place check marks for results on the How To Perform Trouble Diagnosis For Quick And Accurate Repair. Reference are provided following the items.
Display Items List
DATA MONITOR MODE
Display Items List
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.