Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE
Section 172 (Instrument Panel)
WARNING: This page is about a different car, the 2002 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
- Description & Operation
- Notes
- Unified Control Meter
- Checking Bulbs
- Warning Lamps
- Anti-Lock Brake Warning Light
- A/T Oil Temperature Warning Light (4X4 Model)
- "ATP" Warning Light (4X4 Models)
- Brake Warning Light
- Charge Warning Light
- Door Open Warning Light
- Engine Oil Pressure Warning Light
- "4WD" Warning Light (4X4 Models)
- Low Fuel Warning Light
- Low Washer Fluid Warning Light (If So Equipped)
- Seat Belt Warning Light & Chime
- Supplemental Air Bag Warning Light
- Tire Carrier Open Warning Light (If So Equipped)
- Indicator Lights
- Cruise Main Switch Indicator Light (If So Equipped)
- Cruise Set Indicator Light (If So Equipped)
- "4WD" Indicator Light (4X4 Model)
- "4WD" Shift Indicator Light (4X4 Model)
- High Beam Indicator Light (Blue)
- Malfunction Indicator Lamp (MIL)
- Overdrive Off Indicator Light (Automatic Transmission Models Only)
- Transfer "4LO" Position Indicator Light (4X4 Model)
- Turn Signal/Hazard Indicator Lights
- Warning Chime
- Component Locations
- Trouble Shooting
- System Tests
- Notes
- Symptom Chart (Unified Control Meter)
- Symptom Chart (Warning Chime)
- Power Supply & Ground Circuit Tests
- Engine Revolution Signal Tests
- Vehicle Speed Sensor Tests
- Fuel Level Sensor Unit Tests
- Thermal Transmitter Tests
- Diagnostic Procedure 1 (Lighting Switch Input Signal Tests)
- Diagnostic Procedure 2 (Key Switch Insert Signal Tests)
- Diagnostic Procedure 3 (Seat Belt Buckle Switch Tests)
- Diagnostic Procedure 4
- Fuel Warning Lamp Sensor Test
- Component Tests
- Removal & Installation
- Wiring Diagrams
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.