2004 Nissan-Datsun Sentra SE-RFACTORY OEM SERVICE PROCEDURE

With Consult-II

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Wait at least 10 seconds.

    If the result is NG, go to "DIAGNOSTIC PROCEDURE ".

    If the result is OK, go to following step.

  4. Check "COOLANT TEMP/S" value.

    If "COOLANT TEMP/S" is less than 60°C (140°F), the result will be OK.

    If "COOLANT TEMP/S" is above 60°C (140°F), go to the following step.

  5. Cool engine down until "COOLANT TEMP/S" is less than 60°C (140°F).
  6. Wait at least 10 seconds.
  7. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: DTC Confirmation Procedure With CONSULT-II (P0181)
    G00782395Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.