Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Procedure
- CHECK DTC WITH UNIFIED METER AND A/C AMP.
Refer to SELF-DIAGNOSTIC RESULTS" ".
OK or NG
- OK: GO TO 2.
- NG: Go to "FUEL LEVEL SENSOR SIGNAL INSPECTION 1 ".
- CHECK FUEL TANK TEMPERATURE SENSOR POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect fuel level sensor unit and fuel pump harness connector.
- Turn ignition switch ON.
- Check voltage between fuel level sensor unit and fuel pump terminal 4 and ground with CONSULT-II or tester.
Voltage: Approximately 5V
OK or NG
- OK: GO TO 4.
- NG: GO TO 3.
- DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors M9, B2
- Harness for open or short between ECM and fuel level sensor unit and fuel pump
- Repair harness or connector.
- CHECK FUEL TANK TEMPERATURE SENSOR GROUND CIRCUIT FOR OPEN AND SHORT
- Turn ignition switch OFF.
- Disconnect unified meter and A/C amp. harness connector.
- Check harness continuity between fuel level sensor unit and fuel pump terminal 5 and unified meter and A/C amp. terminal 36. Refer to WIRING DIAGRAM .
Continuity should exist.
- Also check harness for short to power.
OK or NG
- OK: GO TO 6.
- NG: GO TO 5.
- DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors B2, M9
- Harness for open or short between "fuel level sensor unit and fuel pump" and "unified meter and A/C amp."
- Repair open circuit or short to power in harness or connector.
- CHECK FUEL TANK TEMPERATURE SENSOR
Refer to "COMPONENT INSPECTION ".
OK or NG
- OK: GO TO 7.
- NG: Replace fuel level sensor unit.
- CHECK INTERMITTENT INCIDENT
Refer to "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT ".
- INSPECTION END.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
