Ignition Timing: Testing and Inspection

2004 Nissan-Datsun Sentra L4-2.5L (QR25DE)SECTION Testing and Inspection
IGNITION TIMING
Any of following two methods may be used.

Method A
1. Slide the harness protector of ignition coil No. 1 to clear the wires.




2. Attach timing light to the wires as shown in the figure.
3. Check ignition timing.

Method B




1. Remove No. 1 ignition coil.







2. Connect No. 1 ignition coil and No. 1 spark plug with suitable high-tension wire as shown, and attach timing light clamp to this wire.




3. Check ignition timing.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.