Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2004ALTIMA S, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCEENGINE CONTROL SYSTEM - 2.5LDTC P0442: EVAP CONTROL SYSTEMDTC CONFIRMATION PROCEDUREWITH GST
2004 Nissan-Datsun Altima S, Automatic
With GST
2004 Nissan-Datsun Altima S, AutomaticSECTION With GST
NOTE:
Be sure to read the explanation of Driving Pattern on
DRIVING PATTERN before driving vehicle.
- Start engine.
- Drive vehicle according to Driving Pattern, DRIVING PATTERN
- Stop vehicle.
- Turn ignition switch OFF and wait at least 10 seconds and then turn ignition switch ON.
- Select MODE 7 with GST.
- If P0442 is displayed on the screen, go to "DIAGNOSTIC PROCEDURE ".
- If P0441 is displayed on the screen, go to DIAGNOSTIC PROCEDURE for DTC P0441.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.