Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2004ALTIMA S, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLABS & ABS/TCSBRAKE CONTROL SYSTEM - TCS/ABSTROUBLE DIAGNOSISCONSULT-II FUNCTIONCONSULT-II MAIN FUNCTIONNOTES
2004 Nissan-Datsun Altima S, Automatic
Consult-II Main Function: Notes
2004 Nissan-Datsun Altima S, AutomaticSECTION Notes
CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.
FUNCTION CHART
| Diagnostic test mode | Function | Reference |
|---|---|---|
| SELF-DIAGNOSTIC RESULTS | Self-diagnostic results can be read and erased quickly. | "SELF-DIAGNOSIS PROCEDURE" |
| DATA MONITOR | Input/Output data in the ABS actuator and electric unit (control unit) can be read. | "DATA MONITOR PROCEDURE" |
| CAN DIAG SUPPORT MNTR | The results of transmit/receive diagnosis of communication can be read. | "CAN COMMUNICATION " |
| ACTIVE TEST | Diagnostic Test Mode in which CONSULT-II drives some actuators apart from the ABS actuator and electric unit (control unit) and also shifts some parameters in a specified range. | "ACTIVE TEST PROCEDURE" |
| FUNCTION TEST | Conducted by CONSULT-II instead of a technician to determine whether each system is "OK" or "NG". | - |
| ECU PART NUMBER | ABS actuator and electric unit (control unit) part number can be read. | - |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.