Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Starter No-Load Test
Connect starter in series with a 12-volt battery and bench tester (with 1000-amp ammeter). Operate starter. If amperage exceeds maximum specification or if RPM is less than minimum specification, repair or replace starter. See STARTER NO-LOAD TEST SPECIFICATIONS table.
| Application | Maximum Amps | Minimum RPM |
|---|---|---|
| QG18DE | 90 | 2600 |
| QR25DE | 90 | 2500 |
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.