Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSNISSAN-DATSUN2003FRONTIER BASE, STANDARDREPAIR AND DIAGNOSISBRAKESTRACTION CONTROLBRAKE CONTROL SYSTEMABSTROUBLE DIAGNOSISCONSULT-II FUNCTIONSACTIVE TESTOPERATION PROCEDURE

2003 Nissan-Datsun Frontier Base, Standard

Operation Procedure

2003 Nissan-Datsun Frontier Base, StandardSECTION Operation Procedure

CAUTION:

Do not perform active test while driving the vehicle.
Make sure to completely bleed air from brake system.
Active test cannot be performed when ABS warning lamp is on.

Connect the CONSULT-II connector to the data link connector and start the engine.
Touch "START" on the display.
Touch "ABS" and "ACTIVE TEST".

Fig 1: Identifying CONSULT-II Display Screen - ACTIVE TEST
Courtesy of NISSAN MOTOR CO., U.S.A.
Test item selection screen is displayed.

Fig 2: Identifying Test Item Selection Screen

Courtesy of NISSAN MOTOR CO., U.S.A.

Touch necessary test item.
Touch "START".
Carry out the active test by touching screen key.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.