Data Monitor (SPEC) Mode

2003 Nissan-Datsun Frontier Base, StandardSECTION Data Monitor (SPEC) Mode

For DATA MONITOR (SPEC) mode descriptions, see DATA MONITOR (SPEC) MODE DESCRIPTIONSΒ  table.

DATA MONITOR (SPEC) MODE DESCRIPTIONS

Monitored Item Description
MAS A/F SE-B1 [V] The signal voltage of the mass air flow sensor specification is displayed. When engine is running, specification range is indicated.
B/FUEL SCHDL [msec] "Base fuel schedule" indicates the fuel injection pulse width programmed into ECM, prior to any learned on board correction. When engine is running, specification range is indicated.
A/F ALPHA-B1 Or B2 [%] The mean value of the air-fuel ratio feedback correction factor per cycle is indicated. When engine is running, specification range is indicated. This data also includes the data for the air-fuel ratio learning control.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.