Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2003FRONTIER BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ENGINE PERFORMANCETESTING & DIAGNOSISENGINE CONTROLS - SELF-DIAGNOSTICSDIAGNOSTIC TESTSDTC P0461: FUEL LEVEL SENSORDTC CONFIRMATION TEST (USING GENERIC SCAN TOOL)
2003 Nissan-Datsun Frontier Base, Standard
DTC Confirmation Test (Using Generic Scan Tool)
2003 Nissan-Datsun Frontier Base, StandardSECTION DTC Confirmation Test (Using Generic Scan Tool)
NOTE:
Use the following test to check overall function of fuel level sensor circuit. During this test, 1st trip DTC may not be confirmed.
- To check overall function of fuel level sensor circuit, release fuel system pressure. See FUEL SYSTEM in BASIC DIAGNOSTIC PROCEDURES article. Remove fuel feed hose from fuel level sensor unit located behind access cover, under rear seat.
- Connect a fuel hose to fuel level sensor unit. Place other end of hose into a suitable fuel container. Turn ignition off. Set voltmeter probes between ground and fuel level sensor signal circuit (Orange/Black wire) at ECM terminal No. 46 by backprobing. See Figure or Figure . See Figure . Turn ignition on and monitor voltmeter.
- Using suitable equipment, drain 7.93 Gals. (30.0 L) of fuel from tank. Refill tank with drained fuel. Voltage should change more than 0.03 volt during draining and refilling. If voltage is not as specified, go to DIAGNOSTIC PROCEDURE . If voltage is as specified, system is okay at this time.
CAUTION:
DO NOT use ECM ground terminals when measuring voltage.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.