SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2001SENTRA SE, STANDARD, RS5F70AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 166 (DISC & DRUM)ADJUSTMENTSSTOPLIGHT SWITCH & AUTOMATIC SPEED CONTROL DEVICE SWITCH
2001 Nissan-Datsun Sentra SE, Standard, RS5F70A

Stoplight Switch & Automatic Speed Control Device Switch

2001 Nissan-Datsun Sentra SE, Standard, RS5F70ASECTION Stoplight Switch & Automatic Speed Control Device Switch
WARNING: This page is about a different car, the 2004 Nissan Pathfinder, 2003 Nissan Pathfinder, and 2002 Nissan Pathfinder. However, it is still accessible from the selected car via links, so may be relevant.
  1. Both the stoplight switch and automatic speed control device switches are located below dash panel, at brake pedal bracket. Adjust brake pedal height. See BRAKE PEDAL HEIGHT  and BRAKE PEDAL FREE PLAY  .
  2. Check clearance and position of both the switches. Clearance between brake pedal stopper rubber and threaded end of switch should be 0.012-0.039 in. (0.3-1.0 mm). To adjust, loosen lock nut and turn switch body. After adjustment, tighten lock nuts to 9-11 ft. lbs. (12-15 N.m).
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.