SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN2001SENTRA SE, STANDARD, RS5F70AREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 164 (BRAKES MECHANICAL)BLEEDING BRAKE SYSTEMBLEEDING PROCEDURESTRACTION CONTROL SYSTEM
2001 Nissan-Datsun Sentra SE, Standard, RS5F70A

Traction Control System

2001 Nissan-Datsun Sentra SE, Standard, RS5F70ASECTION Traction Control System
WARNING: This page is about a different car, the 2004 Lexus ES 330. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Do not let brake fluid remain on painted surfaces. Wash it off immediately. With reservoir cap removed, when depressing brake pedal, brake fluid will spray.

Remove reservoir cap. Install hand pump with gauge and hose to reservoir and apply 14.2 psi (1 kg/cm2 ). See upper portion of Fig 1. Connect vinyl tube to bleeder screw of brake actuator and loosen bleeder screw. See lower portion of Fig 1. Bleed air from actuator and tighten bleeder screw to specification. See TORQUE SPECIFICATIONS . Add brake fluid if necessary.

Fig 1: Bleeding Traction Control System
G00031457Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.