Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSNISSAN-DATSUN1996300ZX TURBO, STANDARDREPAIR AND DIAGNOSISDRIVELINES & AXLESDIFFERENTIALS & DRIVE AXLESREAR DRIVE AXLETORQUE SPECIFICATIONS
1996 Nissan-Datsun 300ZX Turbo, Standard
Torque Specifications
1996 Nissan-Datsun 300ZX Turbo, StandardSECTION Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||||||
|---|---|---|---|---|---|---|---|
| Drain & Fill Plugs | 29-43 (39-58) | ||||||
| Drive Pinion Flange Nut | |||||||
| R200 & R200V | 137-217 (186-294) | ||||||
| R230V | (1) 159-318 (216-431) | ||||||
| Drive Shaft Center Bearing | |||||||
| Carrier Bolts | 43-58 (58-78) | ||||||
| Drive Shaft-To-Pinion Flange | |||||||
| Nuts & Bolts | |||||||
| Except R230V | 41-48 (55-65) | ||||||
| R230V | 47-54 (64-74) | ||||||
| Rear Cover Bolts | 29-36 (39-49) | ||||||
| Rear Cover Nut | 65-87 (88-118) | ||||||
| Ring Gear Bolts (2) | |||||||
| Except 300ZX (R200V) | 98-112 (132-152) | ||||||
| 300ZX (R200V) | 130-145 (176-197) | ||||||
| Side Bearing Cap Bolts | 65-72 (88-98) | ||||||
| Side Flange-To-Axle Shaft | 51-58 (69-78) | ||||||
| Wheel Hub Lock Nut | 152-203 (206-275) | ||||||
| Wheel Lug Nut | 72-87 (98-118) | ||||||
|
|||||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.