Customization Function

2017 Mitsubishi Mirage G4 ES, Automatic CVT TransSECTION Customization Function

Using the ETACS system of scan tool (M.U.T.-III), the following functions can be programmed. The programmed information is held even when the battery is disconnected.

Adjustment item (scan tool display) Adjustment item Adjusting content (scan tool display) Adjusting content
Hazard answer back Adjustment of the number of keyless hazard warning light answer back flashes Lock:1, Unlock:2 LOCK: Flashes once, UNLOCK: Flashes twice (Initial condition)
Lock:1, Unlock:0 LOCK: Flashes once, UNLOCK: No flash
Lock:0, Unlock:2 LOCK: No flash, UNLOCK: Flash twice
Lock:2, Unlock:1 LOCK: Flash twice, UNLOCK: Flash once
Lock:2, Unlock:0 LOCK: Flash twice, UNLOCK: No flash
Lock:0, Unlock:1 LOCK: No flash, UNLOCK: Flash once
Lock:0, Unlock:0 No function
Door unlock mode Adjustment of power door locks with selective unlocking All Doors Unlock The first operation of keyless entry system or unlock operation by KOS unlocks all doors.
Dr Door Unlock The first operation of keyless entry system or unlock operation by KOS unlocks the driver's door only, and the second unlock operation within 2 seconds after that unlocks all doors. (initial condition)
Door unlock (Shift "P" position) Adjustment of the auto door unlock (P position) function <CVT> Disable No function (Initial condition)
Enable Always with function
With P/W Lock SW dammy
Timer lock timer Timer lock period adjustment 30 sec 30 seconds (Initial condition)
60 sec 60 seconds
120 sec 120 seconds
180 sec 180 seconds
Horn chirp by keyless Horn chirp by keyless entry system Not sound horn No horn answerback function
Lock any time The horn sounds when the lock button of keyless entry transmitter is pressed once.
W lock any time The horn sounds when the lock button of keyless entry transmitter is pressed twice. (initial condition)
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.