Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSMITSUBISHI2017MIRAGE G4 ES, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)TRANSMISSIONAUTOMATIC TRANSCONTINUOUSLY VARIABLE TRANSAXLE (CVT)SERVICE SPECIFICATIONSNOTES
2017 Mitsubishi Mirage G4 ES, Automatic CVT Trans
Service Specifications: Notes
2017 Mitsubishi Mirage G4 ES, Automatic CVT TransSECTION Notes
| Item | Standard value | |
|---|---|---|
| Transmission fluid temperature sensor resistance kΩ | At 20°C (68°F) | Approximately 6.5 |
| At 50°C (122°F) | Approximately 2.2 | |
| At 80°C (176°F) | Approximately 0.9 | |
| Line pressure solenoid valve coil resistance Ω | Fluid temperature: 20°C (68°F) | Approximately 5.3 |
| Fluid temperature: 50°C (122°F) | Approximately 5.9 | |
| Fluid temperature: 80°C (176°F) | Approximately 6.5 | |
| Primary pressure solenoid valve coil resistance Ω | Fluid temperature: 20°C (68°F) | Approximately 5.3 |
| Fluid temperature: 50°C (122°F) | Approximately 5.9 | |
| Fluid temperature: 80°C (176°F) | Approximately 6.5 | |
| Low brake solenoid valve coil resistance Ω | Fluid temperature: 20°C (68°F) | Approximately 5.3 |
| Fluid temperature: 50°C (122°F) | Approximately 5.9 | |
| Fluid temperature: 80°C (176°F) | Approximately 6.5 | |
| High clutch and reverse brake solenoid valve coil resistance Ω | Fluid temperature: 20°C (68°F) | Approximately 5.3 |
| Fluid temperature: 50°C (122°F) | Approximately 5.9 | |
| Fluid temperature: 80°C (176°F) | Approximately 6.5 | |
| Lockup solenoid valve coil resistance Ω | Fluid temperature: 20°C (68°F) | Approximately 6.1 |
| Fluid temperature: 50°C (122°F) | Approximately 6.8 | |
| Fluid temperature: 80°C (176°F) | Approximately 7.5 | |
| Engine stall speed r/min | "D" range | Approximately 2, 050 - 2, 550 |
| "R" range | Approximately 2, 050 - 2, 550 | |
| Shift lock solenoid resistance Ω | 40 ± 2 | |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.