Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSMITSUBISHI2017MIRAGE G4 ES, AUTOMATIC CVT TRANSREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESTRACTION CONTROLACTIVE STABILITY CONTROL SYSTEM (ASC)WHEEL SPEED SENSORREMOVAL AND INSTALLATIONNOTES

2017 Mitsubishi Mirage G4 ES, Automatic CVT Trans

Removal And Installation: Notes

2017 Mitsubishi Mirage G4 ES, Automatic CVT TransSECTION Notes

CAUTION:

The vehicle speed detection encoder collects any metallic particle easily, because it is magnetized. Make sure that the encoder should not collect any metallic particle. Check that there is not any trouble prior to reassembling it.
The wiring harness for the wheel speed sensor should be routed without twisting.

Pre-removal and post-installation operation

Rear Scuff Plate Removal (Refer to INTERIOR TRIM ) <Rear wheel speed sensor>

Fig 1: Removing/Installing Wheel Speed Sensor Components With Torque Specifications

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.